Wireless Wire Cube Pro — PtP Setup (not pre-paired)¶
Copy-pasteable RouterOS config for a Wireless Wire Cube Pro (CubeG-5ac60ad) point-to-point link built from two un-paired units (not a factory kit). Sets up the 60 GHz primary + 5 GHz backup with automatic failover, tuned for the metro (jumbo MTU for MPLS/VPLS, remote-recovery pre-arm). Both sides shown.
Companion: WIRELESS-60G.md (MTU + recovery). Raw file: wireless-cube-pro.rsc.
Structure verified against a shipped MikroTik factory config. Key points:
- Pairing = /interface w60g station with remote-address set to the other unit's wlan60-1 MAC (both w60g in mode=bridge). On an un-paired pair this station's remote-address is the one manual step; a factory kit ships it pre-filled. Not connect-list (that's the wireless package, not w60g).
- Failover via active-backup bond of the 60 GHz station interface (wlan60-station-1, primary) + wlan1 (5 GHz standby). 5 GHz is plain 802.11ac (band=5ghz-a/n/ac, installation=outdoor), master mode=bridge / slave mode=station-bridge.
- Transparent L2 bridge; admin-mac pinned to the w60g MAC.
- MTU is the only thing added to the factory config (which sets none): raise l2mtu ≥ 1600 on w60g / station / wlan1 / bond / bridge / ether1 and verify it took (60 GHz is the cap) so the link carries MPLS/VPLS.
- Radios manage on the 10.253.232.x/29 subnet (per the factory config).